Advertisement
NOTE: The mounting sleeve must be removed from
the stereo frst! Your stereo may be snapped into its
sleeve. Slide the mounting sleeve (metal shroud)
off the stereo towards the back.
REMOVE SLEEVE FROM STEREO
1. Locate the locking mechanism on your DIN
stereo sleeve (typically) on the side.
2. Slip mounting sleeve towards rear
of stereo and remove.
FLAT FACE DIN/DETACHABLE FACEPLATE/PULLOUT (DIN E) STEREOS
Slide the mounting sleeve (metal shroud) into the panel's stereo opening and bend all available
mounting tabs outward (see inset). Slide the stereo into the mounting sleeve once it has been
fastened to the kit panel until the radio locks into place.
NOTE:
REAR SUPPORT STRAPS NOT INCLUDED.
REAR SUPPORTING THE STEREO ADDS TO THE
INSTALLATION'S STRUCTURAL INTEGRITY.
DIN MOUNTING SLEEVE
(SUPPLIED WITH STEREO)
SHAFT MOUNT INSTALLATION NOTE:
SNAP SHAFT MOUNTING TABS NOT INCLUDED. IF REQUIRED
FOR YOUR STEREO INSTALLATION, CALL 800-821-3695 x3
FOR IMMEDIATE SHIPMENT.
QUICK START GUIDE
STEREO ASSEMBLY
#1504
MOUNTING
PANEL
DIN STEREO
RADIO'S
SUPPLIED
TRIMPLATE
REAR SUPPORT
STRAPS
5
BEND TABS
OUTWARD
Advertisement
