Advertisement
1986-88 Oldsmobile Delta 88
1989-91 Oldsmobile Eighty-Eight Royale
1984-93 Oldsmobile Ninety-Eight
RADIO REMOVAL:
1. Place the gear shift lever
in the D1 position. Pull
the rubber steering
column trim boot towards
the rear of the car.
2. Remove the four screws
from the heater control/vent
trim panel. Very
carefully pull the
entire trim panel
away from the
dash and remove
the trim panel.
3. Extract the single
screw from each end of the padded radio trim panel.
4. Remove the four screws from the bottom of the radio/dash trim panel.
5. Extract the seven screws from the top of the radio/dash trim panel.
6. Unhook the ashtray/light wiring terminal located directly behind the ashtray.
7. Remove the trim panel.
8. Remove the four screws which secure the radio to the dash and slide the radio out of the cavity.
Disconnect the antenna, speaker leads and all the electrical connections, then remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1992-93 Oldsmobile Eighty-Eight Royale
RADIO REMOVAL:
1. Extract the three screws securing the radio trim/dash bezel
from above the instrument cluster and the radio.
2. Remove the screws on each side
of the steering column that
secure the radio trim/dash
bezel. Carefully pull out on the
bezel to remove it.
3. Extract the four
screws securing
the radio to the
dash, pull the radio
from the cavity, unplug all the
connectors and remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1983-84 Oldsmobile Omega
RADIO REMOVAL:
1. Remove the four screws retaining the panel below
the steering column and remove the panel.
2. Extract the four screws from inside the top edge of the instrument cluster trim.
3. Remove the two screws from the lower instrument cluster trim,
one on each side of
the steering column.
4. Remove the dash
trim panel.
5. Remove the four 7mm
hex screws from the radio
brackets/dummy panel. Pull the
radio out of the cavity,
disconnect the antenna, speaker
leads and all the electrical
connections, then
remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
"C1" BRACKET
SPACER
USE HOLE #4
EL ESPACIO
SPACER
EL ESPACIO
"C2"
BRACKET
USE HOLE #4
"C2" SOPORTE USA
ABERTURA NO. 4
"A2" BRACKET
USE HOLE #1
"A2" SOPORTE
USA ABERTURA
NO. 1
"C1" BRACKET USE HOLE #2
"C1" SOPORTE USA
ABERTURA NO. 2
"C2" BRACKET
USE HOLE #2
"C2" SOPORTE USA ABERTURA NO. 2
LEFT SIDE
LADO IZQUIERDA
"C1" SOPORTE
USA ABERTURA
NO. 4
FRONT OF KIT
FRENTE DE
ESTUCHE
BOTTOM
FONDO
"C2" BRACKET USE HOLE #1
"C2" SOPORTE USA
ABERTURA NO. 1
LEFT SIDE
LADO IZQUIERDA
FRONT OF KIT
FRENTE DE
ESTUCHE
23
Read pages 3-6
for kit assembly.
RIGHT SIDE
LADO DERECHO
"D1" BRACKET
USE HOLE #3
"D1" SOPORTE USA
ABERTURA NO. 3
"D2" SOPORTE USA
Read pages 3-6
for kit assembly.
"D1" BRACKET USE HOLE #2
"D1" SOPORTE USA
ABERTURA NO. 2
(CUARTO SOPORTES)
Read pages 3-6
for kit assembly.
RIGHT SIDE
LADO DERECHO
BRACKET USE HOLE #3
"D2" SOPORTE USA ABERTURA NO. 3
SPACER
EL ESPACIO
SPACER
EL ESPACIO
"D2" BRACKET
USE HOLE #2
ABERTURA NO. 2
"B2" BRACKET
USE HOLE #2
"B2" SOPORTE
USA ABERTURA
NO. 2
CUT
OFF TAB
(4 BRACKETS)
ROMPE EL
LENGUETE
"D1" BRACKET
USE HOLE #3
"D1" SOPORTE
USA ABERTURA
NO. 3
"D2"
Advertisement
