Advertisement
1989-91 Chevrolet Blazer/Jimmy-Full Size
1989-91 Chevrolet/GMC Suburban
1989-91 Chevrolet/GMC
Crew-Cab Dually Pickup
RADIO REMOVAL:
1. Remove the eight screws securing the instrument/radio trim panel.
2. Extract the four screws from the steering column bottom trim piece, two on each side of the column.
3. Place the gear selector in low (one) gear to provide additional clearance, then remove the instrument
radio trim panel from the dash.
4. Extract the two bolts securing
the face of the radio; then,
from below the dash,
remove the rear support
bolt from the bottom
of the dash sheet metal.
5. Pull the radio out of the dash
cavity, disconnect the radio
harnesses and antenna,
then remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1997-02 Chevrolet Camaro
RADIO REMOVAL:
1. Carefully pry out on the dash trim bezel to release the fastening
clips, unplug all switches and remove the bezel.
2. Extract two screws securing the radio, unplug and remove.
"A1" BRACKET USE HOLE #2
"A1" SOPORTE USA
ABERTURA NO. 2
LEFT SIDE
LADO IZQUIERDA
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1993-96 Chevrolet Camaro
RADIO REMOVAL:
1. Extract three screws from the bottom edge of the dash below
the glove box and remove the glove box.
2. Extract three screws in the glove box cavity that secure the radio trim bezel to the dash.
3. Extract two screws from the center of the under dash panel below the steering column.
4. Extract two screws at the bottom
edge of the dash
below the steering
column and remove
the underdash panel.
5. Extract two screws from where you
removed the under dash panel to
remove the radio trim bezel.
6. Extract two screws securing
the radio to the dash on the
drivers side and the 10mm
bolt securing the radio
on the passenger side.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
CARRIAGE BOLT
PERNO DE PORTE
FLANGE NUT
TUERCO REBORDE
FRONT OF KIT
FRENTE DE
"B1" BRACKET
USE HOLE #2
"B1" SOPORTE
USA ABERTURA
NO. 2
"B2"
BRACKET USE HOLE #2
"B2" SOPORTE USA ABERTURA NO. 2
BOTTOM
FONDO
ESTUCHE
LEFT SIDE
LADO IZQUIERDA
FRONT OF KIT
FRENTE DE
ESTUCHE
13
Read pages 3-6
for kit assembly.
RIGHT
DERECHO
FBA RIGHT
BRACKET
SOPORTE
DERECHO FBA
Read pages 3-6
for kit assembly.
"B1" BRACKET
USE HOLE #2
"B1" SOPORTE USA
ABERTURA NO. 2
RIGHT SIDE
LADO DERECHO
Read pages 3-6
for kit assembly.
RIGHT SIDE
LADO DERECHO
FBA RIGHT
BRACKET
SOPORTE
DERECHO FBA
Advertisement
