Advertisement
Locate your vehicle on the front cover of this instruction and disassemble the dash.
Does your vehicle have the factory radio? If YES, proceed to next
If NO, go to
If your original radio is secured to the dash with factory mounting bracket(s), use a 10mm
socket wrench to remove the nut and
the bracket(s) as shown.
NOTE: The factory radio may
have brackets on the sides,
top and/or bottom.
TOP/BOTTOM:
Use the supplied carriage bolts and nuts to attach the factory mounting brackets directly to the
kit panel as shown.
NOTE: If your bracket has small notches on it, they will have to be fattened out or fled off in
order to mount the bracket to the top/bottom of the kit (see inset).
SIDES:
Attach the Factory Bracket Adapters FBA to left and right sides of the kit as shown. The FBA's
locator pins should line up with the holes marked #1 on the sides of the kit panel. Be sure to
insert a carriage bolt through the FBA facing outward through
the square hole (see illustration). Repeat for both sides.
NOTE: Top and bottom factory
brackets bolt directly to kit.
Go to
QUICK START GUIDE
PICK YOUR VEHICLE
FACTORY RADIO?
REMOVING FACTORY MOUNTING BRACKETS
ASSEMBLY WITH FACTORY BRACKETS
LOCATOR PIN
CARRIAGE BOLT
FACTORY RADIO
MOUNTING BRACKET
3
REMOVE FACTORY BRACKETS
BEND TAB
FLUSH
FACTORY BRACKET
ADAPTOR "FBA"
HEX FLANGE NUT
Advertisement
