Table of Contents
Advertisement
RedLINK™ error codes
128
Duplicate ID
129
Invalid device type
130
Invalid instance
134
Weak signial. Move wireless device to a different location and try again.
137
Maximum number of clients reached.
138
No response
152
Out of order
153
Timeout
For full list of error codes, please refer to your equipment's technical service manual.
Replacing system components
NOTE: Only use Mitsubishi Electric components or other designated components for installation.
Failure to comply may damage the product or cause a hazardous condition.
Remote controller
To replace a remote controller, install batteries and follow the procedures on page 4 to link it to
the wireless network. If necessary, modify settings as needed (see tables on pages 7–8).
Wireless receiver
After installing a new wireless receiver, you must unenroll the remote controller so it can
communicate with the new equipment, as described below.
There are three ways to unenroll the controller from the old receiver:
• Press and hold the Menu button for 5 seconds to enter the Advanced Menu. Touch
select UNENROLL DEVICE. Touch Select. Connect the new receiver.
• Enter the Advanced Menu. Touch
select FACTORY. Touch Select. Touch Yes to confirm. Connect the new receiver.
• If the remote controller is on the "Wait" screen, press and hold the bottom-center of the
screen for 5 seconds. Connect the new receiver.
To remove all wireless devices:
1. Press and hold the CONNECT button on the wireless receiver for 10 seconds.
2. To reconnect, see procedure on page 4.
or
to select RESET. Touch Select. Touch
11
or
to
or
to
Hide quick links:
Advertisement
Table of Contents
