• Connect the other end of that fiber cable to the
second Repeater's TX connector.
Figure 3-3. Step 2. Connect the host signal to the Repeater near the
host to the Repeater near the terminal device.
3. Connect the Repeater near the terminal device to the
terminal device.
Twisted-pair:
Install a balun (part number 50370) between the RJ-45
cable and the terminal device coax connector.
• Install the balun at the terminal device's coax
connector.
• Connect the male RJ-45 plug connector on one
end of the cable to the female RJ-45 connector
marked "UTP/STP" on the Repeater.
Repeater
NOTE
CHAPTER 3: Installation
Repeater
15