3270 REPEATER—FIBER
All cable connections to the Repeater must be at least
1.8-m (6-ft.) long.
Host 317x/327x
STEP 1: Connect the host signal
to the Repeater.
1. Connect the host signal to the Repeater.
Set the configuration switch (located on the side of the
Repeater) according to site requirements, using the
following switches.
Switch 1
Switch 2
12
3. Installation
NOTE
Repeater
Fiber
STEP 2: Connect the Repeater near the host
to the Repeater near the terminal device.
Figure 3-1. Installation.
NOTE
NOT USED
UP = Twisted Pair
DOWN = Coax
Repeater
STEP 3: Connect the Repeater near the
terminal device to the terminal device.
Terminal