Using Tls In Vista; Figure 46 Vista Security: Additional Information Required; Figure 47 Vista Security: Enter Credentials - ZyXEL Communications NWD210N User Manual

2 In the WPA, WPA2 or 802.1x security screen (see
Section 4.3.1.4 on page
and Password fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.

Figure 46 Vista Security: Additional Information Required

6 The Enter Credentials screen displays. Enter your User name and Password for the
network to which you want to connect.

Figure 47 Vista Security: Enter Credentials

If you are not sure what to enter, contact your network administrator.
7 Click OK. The Enter Credentials screen disappears and the NWD210N tries to connect
to the network. The ZyXEL utility's Link Info screen displays, showing the connection
status (see
connection, you have successfully completed the procedure.

4.6.2 Using TLS in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using TLS in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
4.3 on page
NWD210N User's Guide
54), select PEAP as the EAP Type. Note that the Login Name
Section 4.2 on page 47). If the Link Info screen displays an active
49), or configure a profile (see
Chapter 4 Wireless Configuration
Section 4.3.1.3 on page 52
Section 4.4 on page 56) in the normal way.
and
Section
65