Table of Contents
Advertisement
Table 29 Device Operation > Device Configuration > Network > WAN Backup > Advanced
(Prestige) (continued)
LABEL
Nailed-Up
Connection
Connect on Demand
Max Idle Timeout
Budget
Allocated Budget
Period
Back
Apply
Reset
5.3.9 Advanced Modem Setup (Prestige)
Click Edit in the Advanced Modem Setup field. See the section on ZyWALL advanced
modem setup on
5.4 Wireless Card
This section shows you how to configure the Wireless Card screens. These screens may vary
depending on which model you're configuring. Please see the device's User's Guide for more
information about any of these screens or fields.
5.4.1 Wireless and Wireless Security Settings
This screen depends on the device type and firmware version.
Use this screen to configure wireless and wireless security settings. To open this screen, click
Device Operation > Device Configuration > Network > Wireless Card > Wireless Card.
Vantage CNM User's Guide
DESCRIPTION
Select Nailed-Up Connection when you want your connection up all the time.
The device will try to bring up the connection automatically if it is disconnected.
Select Connect on Demand when you don't want the connection up all the
time and specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select
Connect on Demand. The default setting is 0, which means the Internet
session will not timeout.
The configuration in the Budget fields has priority over your
Connection settings.
Type the amount of time (in minutes) that the dial backup connection can be
used during the time configured in the Period field. Set an amount that is less
than the time period configured in the Period field. If you set the Allocated
Budget to 0, you will not be able to use the dial backup connection.
Type the time period (in hours) for how often the budget should be reset. For
example, to allow calls to this remote node for a maximum of 10 minutes every
hour, set the Allocated Budget to 10 (minutes) and the Period to 1 (hour). If
you set the Period to 0, there is no budget control and the device uses the
Connection settings.
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Reset to begin configuring this screen afresh.
page 87
for configuration of this screen.
Chapter 5 Device Network Settings
99
Advertisement
Table of Contents
Troubleshooting
