Table of Contents
Advertisement
Figure 85 Device Operation > Device Configuration > Security > X Auth > RADIUS
The following table describes the fields in this screen.
Table 75 Device Operation > Device Configuration > Security > X Auth > RADIUS
LABEL
Activate Authentication
Server IP
Port
Key
Activate Accounting
Server IP
Port
Key
Apply
Reset
Vantage CNM User's Guide
DESCRIPTION
Enable this feature to have the device use an external authentication server
in performing user authentication.
Disable this feature if you will not use an external authentication server. If
you disable this feature, you can still set the device to perform user
authentication using the local user database.
Enter the IP address of the external authentication server in dotted decimal
notation.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator instructs
you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be
shared between the external authentication server and the access points.
The key is not sent over the network. This key must be the same on the
external authentication server and device.
Enable this feature to do user accounting through an external authentication
server.
Enter the IP address of the external accounting server in dotted decimal
notation.
The default port of the RADIUS server for accounting is 1813.
You need not change this value unless your network administrator instructs
you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be
shared between the external accounting server and the access points.
The key is not sent over the network. This key must be the same on the
external accounting server and device.
Click Apply to save your changes back to the device.
Click Reset to begin configuring this screen afresh.
Chapter 6 Device Security Settings
183
Advertisement
Table of Contents
Troubleshooting
