Remote And Automatic Engine Starts - Pandora SMART PRO V3 User Manual

• "Parking light is not turned off" notification (status)
• Shock sensor (security zone – alarm and warning level)
• Motion sensor (security zone – alarm level)
• Tilt sensor (security zone – alarm level)
• OE alarm system status via CAN, additional sensor (status, security zone – alarm and warning level)
• Turning ignition on (status, security zone – alarm level)
• Opening doors (status, security zone – alarm level)
• Opening a trunk (status, security zone – alarm level)
• Opening a hood (status, security zone – alarm level)
• Pressing brake (status, security zone – alarm level)
!
*O
UTSIDE TEMPERATURE IS AVAILABLE BY AN ADDITIONAL DEVICE
( .
SEE LOADER PANDORAINFO

Remote and automatic engine starts

The system allows for remote engine start using the "remote engine start" command from the
mobile application or preconfigured automatic engine start function. Remote start can be used to heat
engine and interior, charge battery or to cool the interior with air conditioning.
Remote and automatic starts can only be used when the system is armed. While the system is in
remote or automatic start mode, it keeps performing all security functions of all of the security zones
excluding a shock sensor (the system can be configured to not disable the shock sensor during a remote
engine start). To compensate it, the motion sensor sensitivity and responsiveness will be increased. If
any security zone will be triggered, the engine will be immediately stopped and alarm mode will be
triggered.
When using the remote and automatic engine start functions, make sure that a car is secured with
handbrake or some other means of fixating the car on a parking position. Remote and automatic engine
start on automatic transmission cars will only occur, if a transmission selector lever was left in the «P»
position.
If a car has manual transmission, remote or automatic start will only occur if the program neutral
procedure was followed when the car was arming.
AN EXAMPLE OF THE "PROGRAM NETURAL" PROCEDURE
1. When the engine is running, fixate the car with the handbrake and put gear lever to the neutral
position. Program neutral procedure will be switched on automatically (by default system settings).
2. Turn the key in the ignition lock to the OFF position (the engine should still be running) and take
U S E R M A N UA L
. ).
COM
( "A
SEE THE DDITIONAL DEVICES
" ) CAN-
SECTION OR BY BUS DATA
13