Setting Parameters Via The Cpu Link System (For S10V Controllers); Figure 4-7 [[S10V] Cpu Link System] Window (Initial State); Figure 4-8 [Communication Type] Window - Hitachi LQE550 User Manual

4.6.3 Setting parameters via the CPU link system (for S10V controllers)

The CPU link system for S10V controllers or, simply, the S10V CPU link system supports the
setting and editing of parameters either in online mode or offline mode. It also supports both the
printing of set parameters on a selected printer and their CSV(comma-separated values)-output to
a specified file.
(1) Procedure for setting and editing parameters in online mode
① Start the CPU link system and make sure that the [[S10V] CPU LINK SYSTEM]
window as shown below is displayed. As shown, the
PCs edition compare
connection is established between the CPU link system and the programmable controller.

Figure 4-7 [[S10V] CPU LINK SYSTEM] Window (Initial State)

② Click on the
shown below will then appear. If you want to change the current connection with the
programmable controller, specify the desired connection and click the
(For details, see "4.8.4 Changing connection.) If not, just click the
instead.
buttons are unclickable. This indicates that at this moment no
Change connection

Figure 4-8 [Communication type] Window

button. The [Communication type] window as
4-9
4 OPERATION
PCs edition and
OK
Cancel
button.
button