Installation And Commissioning; Installing The Hardware; Logo! 8 And Tde; Wlan Access Point - Siemens LOGO! 8 Manual

3 Installation and Commissioning

Installation and Commissioning
3
This chapter describes the steps necessary to start up the example with the code
from the download and the hardware list.
3.1

Installing the hardware

3.1.1

LOGO! 8 and TDE

Please note the respective setup guidelines for LOGO! 8 and LOGO! TDE. Further
information is available in the LOGO! manual in chapter
wiring".
3.1.2

WLAN Access Point

Connect the WLAN Access Point to the network with your LOGO! devices via
Ethernet, e.g. via LOGO! CSM. Further information is available in the manual of the
WLAN Access Point.
Make sure that your WLAN Access Point and the LOGO! have the same basis
Note
address. For example:
IP address master LOGO!:
IP address WLAN:
3.2

Installing the software

Note It is assumed that the necessary LOGO! Soft Comfort V8 software has been
installed on your PC and that you are familiar with the basic handling of this
software.
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2,
192.168.1.10
192.168.1.xxx
09/2018
"LOGO! installation and
18