Waterpik Waterflosser WP-100 Quick Start Manual

1
Prepare the Reservoir:
Remove the reservoir from
Fill
base and fill with lukewarm
water.
Replace the reservoir onto
the base, PRESSING DOWN
FIRMLY to ensure full seating.
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to
the handle and tip into sink. Turn unit
water flows from the tip, turn unit
High
This device is compatible with a voltage system of 240V, 50Hz. Do not plug this device into a voltage system that is different.
QUICK START GUIDE
Replace
high, point
ON until
OFF.
2
Select and Insert Tip:
Insert
4
Adjust Pressure and Pause Control:
For first time
users, adjust
pressure control
to lowest position.
Gradually increase
pressure to your liking.
Low
Mod Model WP-100
NO
Gap
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
You can temporarily stop
water flow by pressing
the pause button on
the handle.
Pause
continued on back