Advertisement
Quick Links
QUICK START GUIDE
1
FIRST USE
Fill reservoir with
warm water and
replace it firmly
on the base.
Model WP-100/112
This device is compatible with a voltage system of 240VAC, 50Hz.
Review full instruction book prior to first use
Insert
Insert tip firmly until
it clicks into place.
Set pressure control dial on
base to high, point the
handle and tip into sink.
Turn unit ON until water
flows from tip, turn unit OFF.
©2016 Water Pik, Inc.
Advertisement
Related Manuals for Waterpik WaterFlosser WP-100
Summary of Contents for Waterpik WaterFlosser WP-100
- Page 1 QUICK START GUIDE Review full instruction book prior to first use FIRST USE Fill reservoir with Set pressure control dial on warm water and base to high, point the replace it firmly handle and tip into sink. on the base. Turn unit ON until water flows from tip, turn unit OFF.
- Page 2 QUICK START GUIDE Review full instruction book prior to first use START WATER FLOSSING LEAN OVER SINK Close lips enough to TO AVOID MESS: PLACE prevent splashing, while still allowing water THE TIP IN YOUR MOUTH to flow from mouth BEFORE TURNING UNIT ON into the sink.