Waterpik Waterflosser WP-70 Quick Start Manual

QUICK START GUIDE
1
Prepare the Reservoir:
Remove the reservoir from base
Fill
and fill with lukewarm water.
Replace the reservoir
.
PRESSING
onto the base,
DOWN FIRMLY
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit:
control slide switch on handle to high, point the
tip into sink. Turn unit
the tip, turn unit OFF.
This device is only compatible with a voltage system of 220-230VAC, 50Hz.
Do not plug this device into a voltage system that is different.
Replace
Set pressure
ON
until water flows from
High
2
Select and Insert Tip:
Press tip firmly into handle. When tip
is properly inserted there should be no
gap between control knob and tip.
Insert
4
Adjust Pressure and Pause Control:
For first time users, adjust pressure
lowest position. Gradually
control to
increase pressure as you prefer.
You can temporarily stop water flow by
pressing the pause button on the handle.
Model WP-70
No Gap
Low
Pause
continued on back