Resetting To The Factory Settings; Troubleshooting - VOLTCRAFT BS-1500T Operating Instructions Manual

13. RESETTING TO ThE fACTORy SETTINGS

• To reset the endoscope to
factory settings, switch it on first.
• Wait until starting is completed and the regular display with date,
time and battery display appears.
• Use a thin object, e.g. a paper clip, to carefully push the Reset
button recessed in the rear.
• Once the display turns black, let go of the button.
• The endoscope basic device restarts and is then reset to factory
settings.
Resetting does not delete any pictures or videos from the
memory card.

14. TROUBLEShOOTING

In purchasing the endoscope, you have acquired a product designed to the state of the art and operationally
reliable. Nevertheless, problems or errors may occur. Therefore, we would like to describe to you how to remove
possible interferences.
The endoscope does not work; nothing is shown on the display:
• The rechargeable battery may be flat. Charge it as described in chapter 8. b).
• Check if the rechargeable battery is connected to the device.
• Reset the device to factory settings as described in chapter 13.
The preview mode is not displayed after activation. you can see only writing:
• Check that your endoscope camera is properly connected to the endoscope basic device.
• Switch off the endoscope, wait for a few seconds and then switch it on again.
• Reset the device to factory settings as described in chapter 13.
No photographs or videos can be recorded:
• Check if the SD card is properly inserted.
• The writing protection of the SD card may be active (small slider at the card is set to "LOCK"). Switch off the write
protection and try again.
• The SD card may be full. Check this by either connecting the endoscope to a computer by USB or using the
display bar D6. Delete some recordings if necessary.
• The SD card partition may be damaged. Format the card with your computer.
• The SD card may be defective. Check the endoscope with another SD card.
42