I) Advanced Settings; J) After Use; K) Attaching The Carry Strap - VOLTCRAFT KBM-700 Operating Instructions Manual

3. Press the
4. To erase all stored values, press and hold the
approx. 3 seconds.
5. Press and hold the

i) Advanced settings

1. Press and hold the
enter advanced settings from pH or TDS mode.
2. In pH mode, press the
or button to select "USA" or "NIST". Confirm your selection with the
3. Press the
firm your selection with the
4. In TDS mode, press the
or button to select the ratio in the range 0.5 - 1.0. Confirm your selection with
the button.
5. To restore the meter to its factory settings, press the
the calibration standard and "Auto Lock") will be reset.

j) After use

• After use, rinse the conductivity cell or pH electrode with distilled water, dry well and seal
with the protective cap.
• The redox probe electrodes must be kept moist after you have finished taking a measure-
ment. Rinse them with distilled water and replace the cap. Ensure that the cap contains
sufficient electrolyte. If necessary, top up the electrolyte in the cap as described in Section
"c) Setting up the redox probe".

k) Attaching the carry strap

You can use the carry strap to carry the meter and hang it on your neck.
• Secure the carrying strap to the holder (1) on the front of the meter. Use the buckle to
secure it in place.
36
(5) and (6) buttons to scroll through the stored values.
button to exit storage mode and return to measuring mode.
(5) and
button (2) to select the calibration standard. Press the
button (4) to turn the automatic freeze function ("Auto Lock") on or off. Con-
button.
button to determine the conductivity/TDS ratio. Press the
and
(6) buttons simultaneously for approx. 3 seconds to
button (7). All settings (apart from
buttons simultaneously for
button (3).