Oriental motor World K Series Operating Manual

Thank you for purchasing ORIENTAL MOTOR products.
Please read this operating manual thoroughly before
installing and operating the motor, and always keep
the manual where it is readily accessible.
<Table of contents>
1. Precautions...............................................Page 1
2. Checking the package contents ...............Page 1
3. Installation ................................................Page 2
4. Connection and Operation........................Page 4

1. Precautions

1.1 Precautions for Installation
• Do not use in a place where there is flammable gas and/or corrosive gas.
• When installing the motor into your equipment, ensure that the motor lead wires are fixed and do not move.
In addition, do not apply any pressure to these lead wires.
• The motor is Class І equipment. Install the motor so as to avoid contact with hands, or ground it to prevent the risk of electric shock.
Dieser Motor ist in Geräten mit Schutzklasse I zu verwenden.
Der Motor ist so einzusetzen, dass er nicht berührt werden kann, bzw. er ist zu erden, um Stromschläge zu verhindern.
• The motor housing must be mounted with a screw and spring washer to the ground point of the equipment.
Die Gehäuse der Motore sind mit einer Schraube und Zahnscheibe sicher mit dem geerdeten Gehäuse des Gerätes zu verbinden.
• Installation must be performed by a qualified installer.
1.2 Precautions for Operation
• The Motor case temperature can exceed 70°C (depending on operation conditions). In case motor is
accessible during operation, please attach the following warning label so that it is clearly visible.
• Always turn off the power to the motor before conducting checks or performing work on the motor.
Thermally protected motors will restart automatically when motor temperature falls bellow a certain level.
• Do not use the electromagnetic brake of the motor as a safety brake.
In the event the overheat protection device (thermal protector) is triggered, the load will not be held in position.
A safety device should be provided separately.

2. Checking the package contents

2.1 Checking the contents
Make sure that you have received all of the items listed below.
If an accessory is missing or damaged,contact the nearest ORIENTAL MOTOR office.
• Motor ..........................1
• Capacitor ....................1 (for only single-phase motors )
2.2 Checking the product name and motor-capacitor combination
This product comes in a combined set consisting of a motor and a capacitor. When the product first arrives, check the name plates to confirm that
you have received the correct motor and capacitor combination.
&#x84; 100V/110V/115V type
Model
5RK60GU-AWMJ
5RK60GU-AWMU
5RK90GU-AWMJ
5RK90GU-AWMU
Motor model Capacitor Model
CH250CFAUL2
5RK60GU-AWM
CH200CFAUL2
CH350CFAUL
5RK90GU-AWM
CH300CFAUL2
World K Series
Electromagnetic Brake Motors
OPERATING MANUAL
5.Time Rating ..................................................... Page 5
6. Locked rotor burnout protection...................... Page 5
7. Troubleshooting .............................................. Page 6
• Capacitor cap ..........................1 (for only single-phase motors )
• This operating manual ............1
&#x84; 200V/220V/230V type
Model Motor model
5RK60GU-CWMJ
5RK60GU-CWM
5RK60GU-CWME
5RK90GU-CWMJ
5RK90GU-CWM
5RK90GU-CWME
5IK60GU-SWM 5IK60GU-SWM
5IK90GU-SWM 5IK90GU-SWM
HM-9097-11
Warning label
Capacitor Model
CH60BFAUL
CH50BFAUL
CH80BFAUL
CH70BFAUL
−
−
1