Opengear OM2200 Series User Manual page 60

3. Complete the new bond details form as in the Bond Form Definitions definitions
table below.
4. Click the Create button to finalize the creation of the new bond. Network connections
from non-primary interfaces will be deleted when the new bond is created.
Edit an Existing Bond
To edit an existing bond:
1. Navigate to the Configure > Network Connections > Network Interfaces page on
the Web UI.
2. Click on the bond that you would like to edit, the bond details are expanded.
Click on the bond Edit button that is located next to the Enable / Disable
3.
toggle buttons.
4. Change the bond details as required in accordance with the Edit Bond Form Defin-
itions table below.
5. Click the Update button to finalize the edit process. Updating the bond will temporarily
interrupt network activity on this interface.
Edit Bond Form Definitions
New Bond Field
Description
Mode
CONFIGURE MENU
Definition
The editable Description field allows you to add a descrip-
tion of the interface. If the description field is not completed
the field will default to a computed value to describe the inter-
face.
The mode determines the way in which traffic sent out via the
bonded interface is dispersed over the real interfaces. Avail-
able modes are:
60