Clutch Drum / Rim Sprocket - Makita Dolmar DCS460 Repair Manual

02 CLUTCH DRUM / RIM SPROCKET

Remove the sprocket guard, bar, and chain.
Remove the circlip 5 with the universal
wrench.
Pull the handguard towards the front handle to
release the chain brake if necessary.
Chain sprocket and clutch drum with
needle bearing
5 Check the chain sprocket 4 for damage and
wear.
Important customer information:
Before installing a new saw chain, always
check the condition of the chain sprocket. A
worn chain sprocket will damage a new saw
4
chain, and must be replaced.
Check the clutch drum needle bearing for
wear and damage.
Assemble the bearing with multi-purpose high-
performance grease (944.360.000).
3
Check the inside of the clutch drum 3 for
damage and wear.
2
Replace the clutch drum if damaged or worn.
Important: Always replace the washer disc
1
1!
Note: Always use a new circlip 5
(927.408.000)!
When assembling the clutch drum, make
sure that the lug of the clutch drum 2 is not
positioned on the oil pump drive. When
inserting, turn the clutch drum slightly.
9