07
IGNITION SYSTEM
2
Installing the ignition armature
NOTE: The high-voltage cable is moulded
onto the ignition system and cannot be
replaced separately.
Insert the armature and turn the screws in
almost all the way.
Lay the high-voltage cable with the ingition
cable as show.
Fasten the ignition cable with screws 2.
Insert the setting gauge (944.500.891)
between the ignition armature and the
fylwheel.
Position the flywheel so that the magnet is
against the armature (gap 0.25 – 0.3 mm).
Press the armature against the gauge towards
the flywheel and tighten the armature screws.
18