Clutch Drum With Chain Sprocket - Makita DCS3500 Repair Manual

02 CLUTCH DRUM AND CHAIN SPROCKET
Remove the sprocket guard, bar, and chain.
Remove the circlip 4 with the universal
wrench.
Remove cup washer 3.
Pull the handguard towards the front grip only
as far as necessary so the clutch drum can be
removed.
Reparaturanleitung PS-4600 / PS-5000
Repair manual DCS3500 / DCS3501 / DCS4300 / DCS4301 / EA3500F / EA3501F / EA4300F / EA4301F / MEA3500L / MEA3500M / MEA4300G / MEA4300L
Clutch drum with sprocket and needle
bearing
4
Check the chain sprocket 2 for damage and
wear.
Important customer information:
Before installing a new saw chain, always
check the condition of the chain sprocket. A
3
worn chain sprocket will damage a new saw
chain, and must be replaced.
Check the clutch drum needle bearing for
wear and damage.
Assembly the bearing with multi-purpose high-
2
performance grease (944.360.000).
Check the inside of the clutch drum for
damage and wear.
Replace the clutch drum if damaged or worn.
1
Note: Always use a new circlip 4
(927.408.000)!
When assembling the clutch drum, make
sure that the lug of the oil pump drive 1 is
not positioned on the oil pump drive. When
inserting, turn the clutch drum slightly.
___
9