07
IGNITION SYSTEM
Removing the flywheel
Block the piston. To do this, see 04 CLUTCH.
Loosen the nut in the direction of the arrow
and remove it along with the washer.
Screw the disassembly mandrel
(944.500.880) onto the threaded end of the
shaft.
Do not screw the mandrel all the way down.
Leave about 2 mm between the mandrel and
the flywheel.
Hold the machine in one hand or place on a
soft surface, and knock the flywheel loose with
a tap on the mandrel.
2
1
Removing the ignition armature
Unscrew 2 screws on ignition armature 1.
Unscrew ignition cable screw 2.
Remove armature 1 and wire.
17