Step 17: Final Inspection
17-1 Inspect your machine to ensure that all fasteners are tight
and components are properly assembled.
Be sure to record the machine serial number in the
Owner's Manual.
Step 18: Attach the Power Cord
18-1 Make sure that the Power Switch is in the "Off" postition.
18-2 Carefully insert the power cord into the A/C inlet at the rear of
the base unit (See Figure 18-1).
NOTICE: Always plug cord into the base before plugging into the
wall outlet.
Note: The TreadClimber
®
grounded (three-prong) wall outlet.
NEVER remove the grounding prong from the power plug
and never use a two-prong adapter without a grounding
wire.
machine plugs into any standard,
Assembly
Do not use or put the machine into service
until the machine has been fully assembled
and inspected for correct performance in
accordance with the Owner's Manual.
Figure 18-1
A/C inlet
Power switch
17
Assembly Manual