Assembly And Installation Instructions - Osram AirZing PRO 5030 UNIV Installation And Safety Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

AirZing™ PRO 5030 UNIV

Equipment and Containment Safeguards

It is the responsibility of the end user to address hazardous exposure risks and to ensure

that people entering the containment area while the product is operating are aware of the

risks, and that appropriate controls and safeguards are in place.

— This product should only be installed by a licensed electrician, and safety measures such as

interlocking devices, lockouts, safety switches or separating on/off switches for the product

from other on/off switches are recommended.

— This product shall be installed on its own electrical safety circuit with disconnecting means

(separate switch) provided by the user. It is the responsibility of the user to ensure that the

power source for this product be accessed only by trained operators and/or a qualified

service technician.

— Wear UV-C blocking eyewear and protective clothing (gloves, long sleeves, etc.) to avoid

direct UV-C exposure to human skin and eyes.

— This fixture is equipped with an IR motion sensor. The sensor provides a 30-second delay

before the lamp will energize. The sensor will also switch off the fixture immediately when

motion is detected in the UV workspace. The fixture will not turn back on itself; it needs to be

powered off and back on again for the fixture to be powered back on.

— A 5-second break is required before switching the product on again right after it switches off,

due to a 3 to 5-second system reset.

— The manual sensitivity feature of the sensor has been disabled by the manufacturer/factory.

The default setting has been set to MAXIMUM sensitivity.

— The workspace should be clear of people and animals during operation.

Included in the box:

— AirZing PRO 5030 UNIV fixture

— OSRAM G30T8/OF (PURITEC

— Installation and Safety Manual for AirZing PRO 5030 UNIV Fixture