Start Up; Operation - Kärcher IVM 60/30 M Z22 Manual

WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Note: Additional regulations can be appli-
cable to dusts with an ignition capacity be-
low 1mJ.
 Bring the appliance to working position
- secure it, if required, with parking
brakes.
 Insert the suction hose (not included)
into the suction hose connection.
 Check the fill level in the dirt container
prior to starting work and empty the
container if necessary.
 Ensure that the dirt container has been
inserted properly. Spring bows must be
clean and lie flat against the dirt con-
tainer. Clean spring bow with a moist
cloth, as necessary.
 Attach the desired accessories (not in-
cluded).
Automatic monitoring of suction
The machine is equipped with a suction
power monitor. The control lamp "Vacuum
pressure" lights up red if the air speed in the
suction hose falls below 20 m/s (see "As-
sistance in case of malfunctions").
Note: The control lamp "negative pressure"
can occasionally light up red during normal
operation (e.g., while working with a floor
nozzle), if the air volume comes down
(cross-sectional reduction) causing a lower
pressure.
Note: There is no defect in this case; only
an indication that, as specified above, the
air volume has reduced and the low pres-
sure has increased.
18

Start up

capacity
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
way, the electrically conductive accesso-
ries approved by the manufacturer prevent
the formation of sparks and current surges.
After vacuuming moist or liquid substanc-
es, observe the notes in chapter "Changing
from wet vacuuming to dry vacuuming".
ATTENTION
Risk of damage! Do not cover the supply
and exhaust air openings on the suction
head.
Close the suction connection
WARNING
Health risk on account of fine dust! If the
suction hose is removed, the suction con-
nection must be closed.
Illustration
 Precisely fit the plug into the suction
connection.
 Insert the plug up to the stop.
Turning on the Appliance
 Plug in the mains plug.
Indicator lamp "Ready for use" lights
up.
 Switch on the appliance at the rotating
knob.
– 4
EN

Operation

Rotating knob
Appliance ON
Appliance OFF