Start-Up; Operation - Kärcher IVR-L 400/24-2 Tc Manual

Start-up

See graphics page for illustrations
1. Bring the device into the working posi-
tion.
2. If necessary, secure the device using the
parking brake.
3. Ensure that the suction head is fitted
correctly.
4. Insert the suction hose into the suction
hose connection.
Illustration B
5. Plug the desired accessory onto the suc-
tion hose.

Operation

For the figures, please refer to the graphics
pages
1. Plug the mains plug into the socket.
2. Switch on the device at the trigger.
Illustration C
The switch has multiple level settings:
0 The device is off.
1 Motor 1 is switched on.
2 Motors 1 and 2 are switched on.
3. Start vacuuming.
Suction process
Note
Only immerse the accessory halfway when
vacuuming liquids to encourage sufficient
air.
Checking the filling level display
See graphics pages for illustration
Illustration D
Note
The red marking on the drain hose shows
the maximum permissible filling level.
ATTENTION
Risk of damage to the device
The liquid container will overflow within a
few seconds of filling.
Constantly check the filling level in the liq-
uid container when filling large quantities of
liquid.
Emptying the liquid container
For the figures, please refer to the graphics
pages
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Empty the liquid container:
a Connect the drain hose to the upper
hose coupling.
Illustration E
b Hold the drain hose over a suitable
collecting container and drain the con-
tents.
4. Dispose of or reuse the contents in ac-
cordance with statutory regulations.
Emptying the liquid container by
See graphics page for illustrations
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Remove the suction head, (see chapter
Removing the suction head).
4. Remove all accessory parts.
5. Prepare the liquid container for empty-
ing:
 By means of tilting the device Tc
(device with tilting device Tc)
a Open the emptying flap on the unlock-
ing lever and latch into the device.
CAUTION
Unfixed emptying flap
Risk of injury and damage due to closing
emptying flap
Lock the emptying flap to the device.
Illustration F
b Open the lock of the liquid container.
Illustration G
 Emptying over a container using a
forklift
a Lift the device above the chassis using
the forklift.
English
tilting
15