Setting Up X5 - Russound XStream X5 Installation Manual

1. Unpack the X5 and all of its contents:
1 X5 Controller Streamer Amplifier
1 Power cord
2 Wi-Fi antennas
1 IR emitter
2. Screw the two antennas on the antennae posts as shown
3. Remove the detachable speaker connector from the X5
Russound X5 Controller Streamer Amplifier Installation Manual
4. Strip back 1/8" of the insulation on the speaker wire and twist the end of
each wire to tighten the bundle of copper strands on each wire.
Snap connector
5. Place the stripped end of the wire into the appropriate terminal and collapse
the latch. Check to make sure there are no strands of copper showing and
check the security of the wire in the connector. Between each terminal, take
caution to not let the wire fray or touch another connection. Each terminal
accepts up to 14 AWG wire.
6. Connect the other end of the wire to each speaker. Be careful to maintain
polarity.
7. Re-connect the detachable speaker terminal.
SETTING UP XSTREAM X5
Speaker wires
7