Installation Overview - Russound XStream X5 Installation Manual

INSTALLATION OVERVIEW

Wiring
If using a wired Ethernet connection, run a CAT-5e cable between the controller
location and the nearest network port. CAT-5e wire is also used for any keypad
connection (optional) and the BTC-1X Bluetooth connection (optional). Use
the T568A wiring configuration for all connections. Refer to the diagrams on
pages 24 and 27. Note: all connections must be made with the power OFF.
Route standard 4 conductor speaker wire to the speaker location. The speaker
connection requires a minimum 4 ohm load. Standard 16-gauge 4-conductor
stranded speaker wire can be run up to 125 feet; 14-gauge wire can be run up
to 250 feet.
Installation
The XStream™ X5 controller can be wall mounted, cabinet mounted or placed
on a shelf in an equipment rack. The controller will occupy very little space.
The side covers can be removed to reveal mounting tabs. Once mounted, the
side panels can be repositioned to hide the mounting hardware. (See diagram
of removable side panels).
Ventilation Requirements
Important: The XStream™ X5 should be situated so that its location or position
does not interfere with its proper ventilation. Do not block vents above the
unit, as it requires ventilation for proper operation. Do not expose to excessive
dust, and do not allow dust to build up on the unit and block vent holes. Do
not place the XStream™ X5 above or below a heat-generating component such
as an audio amplifier.
Be sure to leave at least 2 inches of space to the sides of the unit with open air
flow above. A single-space rack mount vent or about 1.75 inches must be kept
clear above and below the unit.
12 Russound X5 Controller Streamer Amplifier Installation Manual
Mounting on the cabinet
Side Panel
Stud
Note:
Mount side panels back in place before applying power.
Side Panel