Advertisement
Phase One
Blockout Installation Procedure
(during earth or masonry work)
1) A suitable recess to be provided to accommodate
installation blockout/mounting ring assembly B/M.
2) Set installation blockout/mounting ring assembly
B/M in position and ensure that:
a) Arrow R on mounting ring M is pointed towards
the object to be illuminated (wall, tree, column).
b) Mounting ring M is fl ush with surface. If the
fl oor will be tiled or paved afterwards leave an
appropriate gap.
c) Mains supply cable(s) O is of suffi cient length to
connect the sealable junction box J with the cable
E from luminaire.
3) During ongoing earth and/or masonry works, do
not remove the two stickers on fi xing thread holes
D. Ensure that installation blockout/mounting ring
assembly B/M is not damaged and has maintained
its original shape. If necessary use a cover plate.
Phase Two
Luminaire Installation and Electrical Connection
4) Switch off mains electrical supply.
5) Check that rating shown on luminaire label con-
forms with mains electrical supply.
6) Terminate cable E from luminaire housing A and
mains supply cable O (for individual wiring) or
branch cable (for through wiring) in sealable junc-
tion box J to connect cable(s). Follow the sealable
junction box termination instruction included in the
packaging.
7) Peel-off the two stickers on fi xing thread holes D.
Set cables and sealable junction box J inside the
installation blockout/mounting ring assembly B/M.
Caution: When the luminaire is placed inside the
installation blockout B, make sure that there is no
stress on the sealable junction box J or electric
cables (Fig. lll).
8) Loosen the two countersunk screws C (do not twist
out). Insert mounting lever L between head of
countersunk screws C and cover lens. Lift luminaire
housing A into installation blockout/mounting ring
assembly B/M (Fig. IV) while aligning holes D on
mounting ring M.
9) Tighten both countersunk screws C 'hand tight'.
4
Advertisement
