Note For Customers Who Cut Their Own Paper - Canon imageRUNNER ADVANCE C9075S PRO Customer Expectation Document

15.6 Note for Customers Who Cut Their Own Paper

Customers who cut their own paper may experience:
• An increase of paper dust in the machine
• Shortening the life of the machine's fixing rollers due to excessive wear from the
rough side of the cut paper
• Paper jams due to paper dust getting into areas of the machine where it is not
meant to be
• Improper paper feeding
• Paper registration inaccuracies
Follow the precautions below to minimize the above issues:
• Have a process in place to regularly make sure that the cutting blades are
sharpened, and that cuts are made as clean as possible.
• Place the paper with the factory mill cut sides facing to the right (leading edge),
and to the front of the machine when feeding paper from a location other than the
multi-purpose tray. If paper is fed from the multi-purpose tray, place the paper
with the factory mill cut sides facing to the left (leading edge), and to the front of
the machine.
• Pay special attention to the paper grain orientation when cutting it. For more
information on paper grain, see
• The best results for color consistency and front-to-back registration are obtained
by using factory mill cut, digital compatible paper.
Version 1 imageRUNNER ADVANCE C9075S PRO Customer Expectations Document
"Paper Grain and Curl," on p. 52.
Page 53