Hitachi CMU Series User Manual page 9

2. Hazard Warning Statements
The following are the hazard warning statements contained in this manual.
2.1 WARNING Statement
(chapter 3, page 3-3)
If the module emits smoke or foreign odor, immediately switch off the power
supply and investigate the problem cause.
Do not perform any installation, wiring, handling, or internal modification
procedures other than stated in this manual. In no event will Hitachi be
responsible for personal injury or death or any damage to Hitachi's product or
peripheral equipment arising out of the use of such an unauthorized
procedure.
While the power is applied, never touch a terminal strip or connector pin. If
you touch a terminal strip or connector pin while the power is applied, you may
receive an electric shock.
2.2 CAUTION Statements
(chapter 3, page 3-4)
Observe the installation procedure stated in the manual.
If the module is improperly installed, it may drop, become defective, or
malfunction.
Do not allow wire cuttings or other foreign matter to enter the module.
The entry of foreign matter in the module may result in a fire or cause the
module to become defective or malfunction.
Before installing the module, discharge any static buildup from your body
because static electricity may render the module defective.
Properly tighten the screws. If they are inadequately tightened, malfunction,
smoke emission, or combustion may occur.
WARNING
CAUTION
S-6