Cmu Operations; Connecting The Cmu And A Tool System - Hitachi CMU Series User Manual

4 OPERATION

4.1 CMU Operations

Connect the CMU and a tool system on Ethernet to manipulate ladders, HI-FLOW, RPDP, NX,
the Base System, and individual tools. (With the exception of HI-FLOW, RPDP and NX,
CPMS debugger, ladders, the Base System, and tools can be manipulated from the basic module.)
This section describes how to connect the CMU and a tool system.

4.1.1 Connecting the CMU and a tool system

Connect the CMU to a tool system by way of Ethernet.
The CMU can be connected with a tool system in a one-to-one correspondence using a cross
cable or in a 1-to-N correspondence by way of a hub.
Power supply
Run HI-FLOW,
Run ladders task and NX
Basic module
CMU
LPU
Ladder, setup tool, base system,
HI-FLOW, RPDP, NX and operations
Tool system
(PC preloaded with a tool program)
Ethernet connection
(Cross cable or hub connection)
4-2