Sony RCP-3100 Operating Instructions Manual page 7

b CAM PW (camera power) button
Press this button to supply power from the CCU to the camera.
Lighting state Meaning
On Power is being supplied to the camera.
Off Power is disconnected from the camera. It is not
supplied even if the button is pressed.
Slow flashing Power is disconnected from the camera. It is
supplied when the button is pressed.
Fast flashing Camera is starting up.
c Test signal output selection button
This button lights when pressed to output a signal from the test
signal generator.
TEST: Camera test signal
BARS: Color bars signal
Note
When the BARS button is lit, the function of the BARS button
takes priority. To select TEST, press the BARS button to turn
its light off.
d CLOSE (iris close) button
Press this button to close the iris of the lens connected to the
camera.
Pressing it when the auto iris is on changes the iris indication
to CLS (close). Pressing it when the auto iris is off closes the
lens iris without changing the iris indication. Pressing it again
cancels the iris closing, and the previous state of the iris value
is restored.
e CHARACTER (text information) button
CCU character button. Press this button to turn character
output of the CCU on/off, and to switch to the next page. When
this function is on, each press of the button switches to the
next page. In the on state, pressing and holding the button
switches to the last page. In the off state, character output is
stopped. For details about which video output connectors will
support character output, refer to the operation manual for the
connected device.
f STANDARD button
Press this button to recall the standard state of the camera.
After the standard state is recalled, you can cancel the recall
by pressing this button again while it is lit.
g 5600K button
Electronic color temperature correction function button. Press
this button to turn electronic color temperature correction
(5600K) on.
h Assignable button (F1)
You can assign any function to this button using the web menu.
For details, see "Configuring from the Web Menu" (page 17).
i ATW button
ATW (auto tracing white balance) function button. Press this
button to turn ATW on.
j AWB (auto white balance) button
Press this button to start auto white balance adjustment. The
button is lit while this adjustment is in progress and goes out
when adjustment is finished. Pressing it again while
adjustment is in progress will stop automatic adjustment. The
button flashes to indicate the function is stopped. Press again
to stop the flashing indication.
k ABB (auto black balance) button
Press this button to start auto black balance adjustment. The
button is lit while this adjustment is in progress and goes out
when adjustment is finished. Pressing it again while
adjustment is in progress will stop automatic adjustment. The
button flashes to indicate the function is stopped. Press again
to stop the flashing indication.
Menu control block
a Target device selection (CAM/BPU/CCU) buttons
These select the target device for menu control. When a
device is selected, the corresponding button is lit. When all
button indications are not lit, no device is selected and menu
control is disabled.
1 Menu control block
a OVERLAY button
Displays the OVERLAY status of the camera/BPU. The button
cannot be operated.
b DISP button
Press this button to show the operation status (DISP) of the
camera/BPU.
This is disabled when the CCU button on the target device to
control is selected.
c MENU button
Press this button to show the menu of the camera/BPU/CCU.
d SELECT knob
Turn this knob to move the cursor when the menu/operating
status display is displayed. Press the knob to select an item.
e CANCEL button
Press this button to cancel the selected item.
Note
When BARS is selected for the test signal output, CAM/BPU
cannot be selected as the control target. If BARS is selected
when CAM or BPU is lit, the CAM or BPU device selection is
canceled.
7