Pre-Installation Pre-Installation; Introduction; Typical Installation; Clean The Sink Drain Line - InSinkErator 13954 Installation & Use Manual

PRE-INSTALLATION PRE-INSTALLATION
PRE-INSTALLATION PRE-INSTALLATION PRE-INSTALLATION

INTRODUCTION

INTRODUCTION INTRODUCTION
INTRODUCTION INTRODUCTION
The In-Sink-Erator commercial food waste disposer is
UL® approved when installed in conjunction with In-
Sink-Erator mounting adapters and controls (see Figure
1 for a typical installation).
See Table 1 on page 3 for the approved disposer/
mounting adapter combinations. See Table 3 on page
7 for the approved disposer/control combinations.
Important Important
Important Important - these installation instructions are for the Important
benefit of the installing contractor. In-Sink-Erator and/
or the In-Sink-Erator Factory Authorized Service Centers
do not make original installations. For technical
information not covered in these instructions, contact
the supplier, an In-Sink-Erator Field Sales Representa-
tive, or the In-Sink-Erator Factory in Racine, Wisconsin
at 1 (800) 558-5712.

TYPICAL INSTALLATION

TYPICAL INSTALLATION
TYPICAL INSTALLATION TYPICAL INSTALLATION TYPICAL INSTALLATION
A typical commercial disposer installation
with a sink bowl incorporates the following
connections (see Figures 1 & 9):
• Water shut-off valve
• Siphon breaker
• Solenoid valve
• Start/stop switch
• Sink or trough
S B
INK OWL
(
USED ONLY ON
M
IXING
D W I
OUBLE ATER NLET
18" )
BOWLS SINKS
S B
INK OWL
S B
INK OWL
W I
ATER
Figure 1 Figure 1 Figure 1: Typical Commercial Disposer Installation Figure 1 Figure 1

CLEAN THE SINK DRAIN LINE

CLEAN THE SINK DRAIN LINE CLEAN THE SINK DRAIN LINE
CLEAN THE SINK DRAIN LINE CLEAN THE SINK DRAIN LINE
With a drain auger, clear away all hardened waste
material in the horizontal drain pipe running from the
drain trap to the main waste line.

REQUIRED TOOLS/MATERIALS

REQUIRED TOOLS/MATERIALS
REQUIRED TOOLS/MATERIALS REQUIRED TOOLS/MATERIALS REQUIRED TOOLS/MATERIALS
The following items are needed to install the disposer:
• Screwdriver
• Adjustable wrench
• Pipe wrench
• Wire nuts
• 7/16" nut driver
The following items may be needed to install the
disposer:
• Plumbers putty
• Hacksaw
• Drain auger
T
EE
NLET
B
2
V
C
H
OT
S -O
HUT FF
V
ALVE
I
S /S
ODY NLET
TART TOP
S
WITCH
S B
IPHON REAKER
ALVE
F C
LOW ONTROL
V
ALVE
S V
OLENOID ALVE
W P (1/2")
OLD ATER IPE
W P (1/2")
ATER IPE