Special In-Sink-Erator Mountings - InSinkErator 13954 Installation & Use Manual

# 6, # 7, & SINK BOWL MOUNTING ADAPTERS # 6, # 7, & SINK BOWL MOUNTING ADAPTERS # 6, # 7, & SINK BOWL MOUNTING ADAPTERS
# 6, # 7, & SINK BOWL MOUNTING ADAPTERS # 6, # 7, & SINK BOWL MOUNTING ADAPTERS
1 . Place the mounting flange (1 1 1 1 1 ) over the existing
collar adapter connection lip or sink bowl flange
(this may require some force).
2. Push the mounting flange up out of the way and fit
the groove in the mounting gasket (2 2 2 2 2 ) onto the
connection lip. Make sure the gasket is fully seated
on the flange.
3. Push the mounting flange down over the mounting
gasket, fitting the threaded mounting flange fasten-
ers into the recesses in the top of the mounting
gasket.
# 6 C A
OLLAR DAPTER
(1) M F
OUNTING LANGE
(2) M G
OUNTING ASKET
(3) F G
LAT ASKET
D B F
ISPOSER ODY LANGE
1/4" S
Figure 4: Figure 4: Figure 4: # 6 Mounting Assembly Figure 4: Figure 4:

SPECIAL IN-SINK-ERATOR MOUNTINGS

SPECIAL IN-SINK-ERATOR MOUNTINGS
SPECIAL IN-SINK-ERATOR MOUNTINGS SPECIAL IN-SINK-ERATOR MOUNTINGS SPECIAL IN-SINK-ERATOR MOUNTINGS
When installing an In-Sink-Erator commercial disposer to a non-In-Sink-Erator style sink bowl, a special mounting
adapter kit is required. The special mountings are described in the Mounting Adaptor Selection Guide (for more
information, call 1-800 558-5712 and select option 4 ). Figures 6-8 show examples of non-In-Sink-Erator style
sinks. (Mounting instructions are included in each special mounting adaptor kit.)
Figure 6: Figure 6: Outward Flange Figure 6:
Figure 6: Figure 6:
CREW
Figure 7: Inward Flange Figure 7: Figure 7:
Figure 7: Figure 7:
DISPOSER MOUNTING DISPOSER MOUNTING
DISPOSER MOUNTING DISPOSER MOUNTING DISPOSER MOUNTING
4. From the bottom, insert two screws through oppo-
site sides of the flat gasket (3 3 3 3 3 ) and mounting flange,
into the threaded fasteners in the existing flange.
(The flat gasket is used only
assembly .) The screws should protrude about 1/4
inch below the mounting gasket.
5. Position the disposer beneath the mounting gasket
and raise it to engage the two protruding screws in
the disposer body flange keyhole slots. Secure the
remaining screws and position the disposer cor-
rectly for the plumbing connections. (For 3-10 H.P.
disposers, adjust the legs to support the disposer.)
# 7 C
OLLAR
S
INK
(1) M
OUNTING
(2) M
OUNTING
D B
ISPOSER ODY
1/4" S
Figure 5: # 7 or or or or or Sink Bowl Mounting
Figure 5: Figure 5: Figure 5: Figure 5:
5
only only in the #6 mounting only
only
A
DAPTER
or
B
OWL
F
LANGE
G
ASKET
F
LANGE
CREW
Assembly
Figure 8: Figure 8: Straight Flange Figure 8:
Figure 8: Figure 8: