Table of Contents
Advertisement
TAP and
HOLD
H-SWIPE
V-SWIPE
4.4
HOME BROWSING
Use H-SWIPE to move through the screens. The logic implements a circular browsing: H-SWIPE to left or to
right is possible. A programmable timeout is implemented to return HOME from any lateral screen.
4.5
STAND-BY MODE
When in HOME screen, H-swipe to go to the Virtual Keyboard screen and then touch the OFF icon for 3 sec.
All outputs and alarms are deactivated in Stand-by mode.
4.6
PROGRAMMING MENU
It is possible to unlock the programming menu by touching any area of the display for 3 sec. Both SET and
PRG icons will blink until the programming menu is unlocked.
4.7
SETPOINT MENU
When in Programming Menu, it is possible to enter the Setpoint Menu by touching the SET icon for 3 sec.
Both SET and PRG icons will blink until the Setpoint Menu is unlocked. Both PROG LEVEL icons start
toggling to indicate that the visualized value is editable. Press the BACK icon to exit (come back to the
Programming Menu) without saving.
1592040010 XRi30-31T EN v1.2 2020.08.26
Press any place of
the screen with a
finger for 3 sec
Drag a finger across
the screen, from left
to right or from right
to left
Drag a finger across
the screen, from top
to bottom or from
bottom to top
(overlapping only one
of the digits)
Enter / Save: use this to enter Programming
mode or Parameter menu and to save
modifications. When in Virtual Keyboard, use this
on the "ONOFF" to switch OFF and ON the
device.
Browse: use horizontal swipe (right to left or left
to right) to browse through HOME, Virtual
Keyboard and Info View. When in programming
mode: use horizontal swipe to browse through
parameter menu.
Modify: use vertical swipe (from top to bottom or
bottom to top) to change a parameter value.
XRi30T-XRi31T
10/42
Advertisement
Table of Contents
