Nicols CONTROL 24 Instruction Manual page 19

NOTE: when sending file dump in open loop mode, you should set up receiving mode
for the receiver, otherwise receiving is disable.
7) When the power voltage is too low, the display shows LOP, now you should check whether
the power is OK. It is normal that LOP is appeared for a short while just after power is turned on.
21. MIDI RUN
1) If MIDI data is not received within 10minutes, the channel and program turned on by MIDI
will be cleared.
2) When sending or receiving file dump, the device ID is 55H .All
Information (include system exclusive) is sent or received in file dump. You can send SCENE
program to storage or another unit, you can also receive SCENE program from storage or another
unit.
3) This unit sends or receives NOTE information. Relevant functions are as follows:
19