Feed Start Sensors And Feed Encoder - Ricoh JP5800 Service Manual

PRINTING SECTION

6.2.2 FEED START SENSORS AND FEED ENCODER

1. First, remove the pressure cylinder (see the C229 service manual).
2. From the rear of the machine, swing out the MPU.
3. Disconnect the connectors [A] from the rear of the machine.
4. Remove the feed encoder [B], paper table feed start sensor [C], and paper tray
feed start sensor [D].
CAUTION: Check if there is a
gap [A] between the
sensor bracket and
the printing pressure
release arm [B].
There must be no gap
or less than 0.2 mm.
[D]
[B]
[A]
6-16
1 March, 2000
[C]
[A]
C232R500.WMF
[B]
C232R502.WMF