Advertisement
that the emergency mode has been activated. The background of the display will change colour
and all the zone keys will turn green to indicate general pre-selection.
MICROPHONE CONSOLE VA-FMCT-500
general pre-selection.
2. Press the PTT key and hold it down. The red ALARM LED will light up and the green indicator will show that it is possible
to speak via the microphone. If no particular zones have been selected in advance, the message will be broadcast in all
Press the PTT key and hold it down. The red ALARM LED will light up and the green indicator will
the zones. If you wish to address the message only to some specifi c zones or groups of zones, see point 2.4 (sending
show that it is possible to speak via the microphone. If no particular zones have been selected
out messages to selected broadcasting zones,
in advance, the message will be broadcast in all the zones. If you wish to address the message
and press the EMERGENCY button.
only to some speci c zones or groups of zones, see point 3.4, Sending out messages to selected
broadcasting zones (page 28).
N.B.: Remember that the PTT key has priority over any pre-recorded message already being sent out.
NOTE: An emergency condition can be stopped only by a station with a higher priority or by local commands by the VA-500.
sent out.
The status of the EMERGENCY key indicates the condition of the system:
• OFF:
Emergency de-activated
NOTE: An emergency condition can be stopped only by a station with a higher priority or by
• Flashin:
Emergency under way, activated by another station or by local commandsby the system
local commands by the system (VAIE 6500 or VAC 2006).
The status of the EMERGENCY key indicates the condition of the system:
• Steady ON: Manual emergency activated from the station itself
• OFF
= emergency de-activated.
All the keys are active so as to enable the operator to manage the emergency.
• Flashing
= emergency under way, activated by another station or by local commands
by the system.
• Steady ON
= manual emergency activated from the station itself.
All the keys are active so as to enable the operator to manage the emergency.
2.3. Sending out pre-recorded evacuation / alert messages
To send out pre-recorded evacuation or alert messages (stored in the memory of the control unit connected to the
3.3
Sending out pre-recorded evacuation/alert messages
VA-FMCT-500), after activating the emergency mode (see point 2.2) press ALERT or EVAC to send out an alert or evacuation
To send out pre-recorded evacuation or alert messages (stored in the memory of the control unit
connected to the TSC6000-EN), after activating the emergency mode (see point 3.2) press ALERT
message respectively in the broadcasting zones.
or EVAC to send out an alert or evacuation message respectively in the broadcasting zones.
The indicators (I) will turn red: if the evacuation message (EVAC) was selected they will remain steady
ON. If the alert message (ALERT) was selected they will be ashing.
The indicators (I) will turn red: if the evacuation message (EVAC) was selected they will remain steady ON. If the alert message
(ALERT) was selected they will be flashing.
Again in this case, if no particular zone was selected beforehand, the selected message will be sent
out by default to all the zones. If you wish to send the message out only in some zones or groups of
zones, consult point 3.4, Sending out messages to selected broadcasting zones (page 28).
To stop pre-recorded messages, hold the RESET/ACK button down until the messages are deactivated
(about 2 seconds).
By pressing the EMERGENCY button again, the messages will be deactivated and the station will
gm-elektronik.swiss | adm@gm-elektronik.swiss
exit the emergency mode. Remember to close the lid again.
TSC6000-EN
26
page
7). To end the hands-free emergency message, release the PTT key
UK
Page 6 | 12
Datasheet 1811.001
Advertisement
