Advertisement
MICROPHONE CONSOLE VA-FMCT-500
3.4. Unit configuration
Unit con guration
This screen page enables the main operating parameters of the station to be set.
3.4.1. Unit address
Each station must have its own univocal address. Press the >> key to select the desired address (four IDs, from 1 to 4, are
available).
• Press «Save changes» to confirm the selection made.
• If you do not wish to save the changes made, press «Escape».
3.4.2. Unit priority
To set the priority level of the station, press the >> key to select the desired level of priority (there are seven possible levels,
from 8 = lowest priority to 14 = top priority).
NOTE: This is a very important parameter as the priority that is chosen determines the operating conditions of the station
both in an emergency condition and in a broadcasting condition.
• Press «Save changes» to confirm the selection made.
• If you do not wish to save the changes made, press «Escape».
4.4.2 Unit priority
To set the priority level of the station, press the >> key to select the desired level of priority (there are
3.4.3. Low-Cut Filter
seven possible levels, from 8 = lowest priority to 14 = top priority).
To set the low-cut fi lter, use the cursor (ON = fi lter activated, OFF = fi lter not activated).
NOTE: This is a very important parameter as the priority that is chosen determines the operating
conditions of the station both in an emergency condition and in a broadcasting condition.
• Press «Save changes» to confirm the selection made.
Press 'Save changes' to con rm the selection made.
• If you do not wish to save the changes made, press «Escape».
If you do not wish to save the changes, press 'Escape'.
3.4.4. PTT Toggle
4.4.3 Low-Cut Filter
The PTT button is factory set to work as a toggle button, that is to say, in order to be active it has to be pressed and then
To set the low-cut lter, use the cursor (ON = lter activated, OFF = lter not activated).
Press 'Save changes' to con rm the selection made.
held down. In a broadcasting condition, however, it is possible to change this feature and set the button so that once it is
If you do not wish to save the change, press 'Escape'.
pressed it will remain down until it is pressed again. To do this, the cursor has to be moved to its «ON» position.
N.B.: This setting will NOT be active in emergency conditions.
4.4.4 PTT Toggle
• Press «Save changes» to confirm the selection made.
The PTT button is factory set to work as a toggle button, that is to say, in order to be active it has
• If you do not wish to save the changes made, press «Escape».
to be pressed and then held down. In a broadcasting condition, however, it is possible to change
this feature and set the button so that once it is pressed it will remain down until it is pressed again.
To do this, the cursor has to be moved to its 'ON' position.
N.B.: This setting will NOT be active in emergency conditions.
3.5 Unit fault list
Press 'Save changes' to con rm the selection.
This screen shows any failures that have occurred to the station. In the example, a problem concerning the station's mi-
crophone is indicated.
Note: The lack, if any, of serial communication with the control unit to which the station is connected is also signalled on
4.5
Unit fault list
This screen shows any failures that have occurred to the station. In the example, a problem concerning
this page.
the station's microphone is indicated.
Note: The lack, if any, of serial communication with the control unit to which the station is
connected is also signalled on this page.
gm-elektronik.swiss | adm@gm-elektronik.swiss
32
TSC6000-EN
33
UK
Page 11 | 12
Datasheet 1811.001
Advertisement
