Advertisement
Quick Links
Deutsch
English
MICROPHONE CONSOLE VA-FMCT-500
VA-FMCT-500
With touchscreen
1
2
3
Front view
1 Socket for microphone (not included) *
2 Status-indicator LED's
3 Touch screen display
4 Reset button
5 Emergency button
* Each station must be completed with an additional micro-
phone to be chosen from among the two following models:
• VA-MG-001, dynamic gooseneck microphone
• VA-MH-001, dynamic hand-held microphone with P.T.T.
Description
Designation and function
The VA-FMCT-500 touch-screen unit for emergency calls enables hands-free messages and pre-recorded evacuation / alert
messages to be sent out. The large backlit display enables management and customisation of calls for every zone of the
system, while specific LEDs provide the main information on the status of the emergency system and concerning any failures.
g+m elektronik ag will not accept any liability for damage to property and / or persons arising out of incorrect use of the equipment or of procedures that do not comply with the
instructions provided in this booklet. g+m elektronik ag strive to improve their products continuously, and therefore reserve the right to make changes to the drawings and technical
specifications at any time and without notice.
gm-elektronik.swiss | adm@gm-elektronik.swiss
4
5
Rear view
A Connector for external 24 VDC power supply
B IN / OUT connectors
C Buzzer switch
Page 1 | 12
A
B
C
Datasheet 1811.001
Advertisement
Summary of Contents for G+M Elektronik VA-FMCT-500
- Page 1 LEDs provide the main information on the status of the emergency system and concerning any failures. g+m elektronik ag will not accept any liability for damage to property and / or persons arising out of incorrect use of the equipment or of procedures that do not comply with the instructions provided in this booklet.
- Page 2 Pin 1 1.1. Connection to compact system VA-500 The VA-FMCT-500 stations have to be connected to the EMG. DESK socket of the compact VA-500 system and used as Importante! Important! alternatives to the emergency systems of the FMD range. There can be at most two stations in each card-cage.
- Page 3 MICROPHONE CONSOLE VA-FMCT-500 2. Operating instructions Each VA-FMCT-500 station is equipped with a set of LED’s (2) for indicating the operating status of the system. The sta- tus corresponding to each LED is indicated below. ALARM This indicates a current «Alarm condition» in the system.
- Page 4 Indicatore tipologia chiamata C. Tastiera selezione zone. Indicatore tipologia chiamata The VA-FMCT-500 station enables the following to be done via the system: D. Indicatore di stato della chiamata a viva voce Tasto per il passaggio alla mod. KEY PAD. D. Indicatore di stato della chiamata a viva voce Tasto per il passaggio alla mod.
- Page 5 Sending out a service (broadcasting) call hands-free. Sending out pre-recorded evacuation /alert messages. Sending out emergency messages hands-free. MICROPHONE CONSOLE VA-FMCT-500 Sending out messages selectively to broadcasting zones. Sending out pre-recorded evacuation /alert messages. Resetting emergency messages / Muting the buzzer to acknowledge a failure.
- Page 6 Sending out pre-recorded evacuation/alert messages VA-FMCT-500), after activating the emergency mode (see point 2.2) press ALERT or EVAC to send out an alert or evacuation To send out pre-recorded evacuation or alert messages (stored in the memory of the control unit connected to the TSC6000-EN), after activating the emergency mode (see point 3.2) press ALERT...
- Page 7 Sending out messages selectively to broadcasting zones The keypad of the VA-FMCT-500 station can be used to pre-select one or more zones to which to send out hands-free or The keypad of the TSC6000-EN station can be used to pre-select one or more zones to which to send...
- Page 8 Zone set in a “disabled Zone set in a “disabled Yellow Yellow Fault condition Fault condition Steady Steady condition” condition” MICROPHONE CONSOLE VA-FMCT-500 Green Green Steady Steady Zone selected Zone selected (key) (key) 2.4.1. Sending out messages selectively hands-free 3.4.1 Sending out messages selectively hands-free 3.4.1 Sending out messages selectively hands-free...
-
Page 9: Settings And Adjustment
By pressing the «Configuration» (B) while viewing the Keypad, it is possible to access the configuration menu of the VA-FMCT-500. To return to the main screen, press «Escape». y pressing the ‘Con guration’ (B) while viewing the Keypad, it is possible to access the con guration enu of the TSC6000-EN. - Page 10 MICROPHONE CONSOLE VA-FMCT-500 TSC6000-EN 3.2. Zone key configuration TSC6000-EN Zone key con guration This screen page enables the 60 available keys to be configured separately and to customise their names. By way of examp- This screen page enables the 60 available keys to be con gured separately and to customise their le, try configuring key no.
- Page 11 MICROPHONE CONSOLE VA-FMCT-500 3.4. Unit configuration Unit con guration This screen page enables the main operating parameters of the station to be set. This screen page enables the main operating parameters of the station to be set. 4.4.1 Unit address Each station must have its own univocal address.
- Page 12 (from 20 to 60 zone selection keys plus 6 function keys) output level 300 mV ncy response 20÷20.000 Hz MICROPHONE CONSOLE VA-FMCT-500 < 1% Technical data Technical data CUT Filter -10dB/100Hz Number of selectable zones 1 to 216 (from 20 to 60 zone selection keys plus 6 function keys) >...