Handling The Inverter; Removing The Sun2000; Packing The Sun2000; Disposing Of The Sun2000 - Huawei SUN2000 Series User Manual

8.1 Removing the SUN2000

Before removing the SUN2000, disconnect both the AC and DC power supplies. After
powering off the SUN2000, wait at least 5 minutes before performing operations on the
SUN2000.
Perform the following operations to remove the SUN2000:
1.
2.
3.

8.2 Packing the SUN2000




8.3 Disposing of the SUN2000

If the SUN2000 service life expires, dispose of it according to the local disposal rules for
electrical equipment waste.
Issue 02 (2019-04-30)
Disconnect all cables from the SUN2000, including RS485 communications cables, DC
input power cables, AC output power cables, and PGND cables.
Remove the SUN2000 from the mounting bracket.
Remove the mounting bracket.
If the original packing materials are available, put the SUN2000 inside them and then
seal them by using adhesive tape.
If the original packing materials are not available, put the SUN2000 inside a suitable
cardboard box and seal it properly.
Copyright © Huawei Technologies Co., Ltd.
8

Handling the Inverter

SUN2000-(3KTL-10KTL)
User Manual
Page 68 of 81