Connecting The Pe Cable - Huawei SUN2000 Series User Manual

No.
4
5
6

5.2 Connecting the PE cable

Precautions

Ensure that the PE cable is properly connected. If it is disconnected or loose, electric
shocks may occur.

Do not connect the neutral wire to the enclosure as a PE cable. Otherwise, electric shocks
may occur.
Additional Information
The SUN2000 has the grounding detection function. This function detects whether the
SUN2000 is grounded properly before its startup, or whether the ground cable is disconnected
when the SUN2000 is running. This function works under limited conditions. To ensure the
safe operation of the SUN2000, ground the SUN2000 properly according to the connection
requirements of the PGND cable. For some power grid types, if the output side of the inverter
is connected to an isolation transformer, ensure that the inverter is properly grounded and set
Isolation settings to Input not grounded, with a transformer to enable the inverter to run
properly.

Issue 02 (2019-04-30)
Name
(Optional) Power grid
scheduling signal cable
AC output power cable
PE cable

The PE point at the AC output port is used only as a PE equipotential point, and cannot substitute for
the PE point on the enclosure.

After the ground cable is installed, it is recommended that the silica gel or paint be applied to the
ground terminal for protection.
According to IEC62109, to ensure safe application in case of the ground cable is
damaged or disconnected, connect the PE cable properly before the grounding detection
Copyright © Huawei Technologies Co., Ltd.
Type
Five-core outdoor cable
Outdoor copper cable
Single-core outdoor
copper cable
SUN2000-(3KTL-10KTL)
User Manual
Specifications

Conductor
cross-sectional area:
2
0.2–1 mm
 Cable outer diameter:
4–11 mm
 Conductor
cross-sectional area:
2
4–6 mm

Cable outer diameter:
10–21 mm
Conductor
cross-sectional area ≥ 4
2
mm
Page 37 of 81