Insert The Film Holder - Plustek OpticFilm 120 Pro User Manual

Insert the Film Holder
Insert the film holder into the scanner through the Front Film Holder Slot until it is
automatically pulled in by the scanner. The scanner will not pull in the film holder if the
USB cable is disconnected.
Please allow about 35 cm in front of the scanner to insert and remove the film holder.
Please DO NOT press any scan buttons until the film holder is completely
inserted. It takes about 30 seconds to locate the film position and detect
Attention
the film type.
Attention
The film holder should be able to be inserted into the scanner
smoothly. Do not push the film holder hard.
On the top side of the film holder you can see '35 mm
Mounted Film Holder' or '35 mm Strip Film Holder' or '120/220
Strip Film Holder'. Always keep this side up for correct scan
results.
18