I/O Signals And Remote Register Assignment; I/O Signals Transferred To/From The Master Module - Mitsubishi Electric GOT1000 Series User Manual

3. I/O Signals and Remote Register Assignment

3.1 I/O Signals Transferred to/from the Master Module

The following table lists the I/O signals assigned to the GOT.
The I/O signals differ according to the set number of occupied stations (1
or 4 stations).
n in the table indicates the address assigned to the Master module by
station number setting.
Signal Direction: GOT
Device No.
Number of occupied stations
1 station 4 stations
RXn0 to
RXn0 to RXnF
RX(n+6)F
RX(n+1)0 to RX(n+7)0 to
RX(n+1)A RX(n+7)A
RX(n+1)B RX(n+7)B
RX(n+1)C to RX(n+7)C to
RX(n+1)F RX(n+7)F
*1 : The remote READY flag is on during startup of the GOT.
It switches on when GOT power is switched on, hardware reset is
made, or the GOT is ready to operate.
If GOT power is on, the remote READY flag is off when offline
operation is performed (during OS installation or screen data
downloading) or while initial processing is executed.
Use it for the interlock ladder when writing or reading data to or from
the CC-Link Master station.
Master module
Signal name
User area RYn0 to RYnF
RY(n+1)0 to
Reserved
RY(n+1)A
Remote
RY(n+1)B
*1
READY flag
RY(n+1)C to
Reserved
RY(n+1)F
4
Signal Direction: Master module
Device No.
Number of occupied stations
1 station 4 stations
RYn0 to
RY(n+6)F
RY(n+7)0 to
RY(n+7)A
RY(n+7)B
RY(n+7)C to
RY(n+7)F
GOT
Signal name
User area
Reserved