Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Caraudio-Systems z.LiNK ZL-MYGIG
Summary of Contents for Caraudio-Systems z.LiNK ZL-MYGIG
- Page 1 z.LiNK-Interface ZL-MYGIG Audio-video-input incl. video-in-motion compatible with Chrysler, Dodge and Jeep vehicles with MYGIG navigation systems AV-input to connect any AV-source to the factory navigation system incl. video-in-motion Version 09.01.2014 ZL-MYGIG...
-
Page 2: Table Of Contents
Contents 1. Prior to installation 1.1. Delivery contents 1.2. Check compatibility of vehicle and accessories 1.3. Pin assignments 2. Connection schema 3. Installation 3.1. Activation of the interface as current AV-source 4. Activation of the video-in-motion function 5. Specifications 6. Technical Support Legal Information By law, watching moving pictures while driving is prohibited, the driver must not be distracted. -
Page 3: Prior To Installation
update, the interface must be sent in at own cost. Labor cost for and other expenses involved with the software-updates will not be refunded. 1. Prior to installation Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. -
Page 4: Pin Assignments
1.3. Pin-assignments Pin-assignment AV-INPUT Connection Cable colour/connector White 22pin MYGIG connector Video input RCA female yellow Video signal ● yellow → pin 9 Ground ● black → pin 10 Audio input RCA female red/white Audio signal (right) ● → pin 14 Audio signal (left) ●... -
Page 5: Connection Schema
2. Connection schema Version 09.01.2014 ZL-MYGIG... -
Page 6: Installation
3. Installation Switch off ignition and disconnect the vehicle’s battery! If according to factory rules disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead. - Page 7 Instruction for example Chrysler C300 Remove the front panel from the centre console, which is attached to multiple clips. Remove the 4 TORX screws and pull the device out of the centre console. Remove the grey female 22pin connector from the rear of the device and connect it to harness TV-MYGIG.
-
Page 8: Activation Of The Interface As Current Av-Source
3.1. Activation of the interface as current AV-source Press RADIO/MEDIA button and after it VES followed by AUX IN 1 via Touch-Screen to select the interface as current AV-source. 4. Activation of the video-in-motion function The video-in-motion can be activated and deactivated by Dip 1 or alternatively by the included loose green cable in connection with a switch (not included in delivery). -
Page 9: Specifications
Temperature range -30°C to +80°C Weight Measurements (box only) B x H x T 70 x 20 x 47 mm 6. Technical Support Caraudio-Systems Vertriebs GmbH manufacturer/distribution In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim email support@caraudio-systems.de Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ®...
Need help?
Do you have a question about the z.LiNK ZL-MYGIG and is the answer not in the manual?
Questions and answers