Store A Contact In Memory; Make A Call To A Registered Number; Bluetooth Mode Settings - JVC KD-X472BT Instruction Manual

Bluetooth®

Store a contact in memory

You can store up to 6 contacts into the number buttons (1 to 6).
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [RECENT CALL], [PHONEBOOK] or
[DIAL NUMBER], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4 Press and hold one of the number buttons (1 to 6).
"MEMORY P(selected preset number)" appears when the contact is
stored.
To erase a contact from the preset memory, select [DIAL NUMBER] in step 2,
store a blank number in step 3 and proceed to step 4.

Make a call to a registered number

1 Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO PRESET" appears if there is no contact stored.

Bluetooth mode settings

1
Press and hold .
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press to exit.
To return to the previous setting item, press
18
ENGLISH
[BT MODE]
[PHONE SELECT]
[AUDIO SELECT]
[DEVICE DELETE]
[PIN CODE EDIT]
(0000)
[RECONNECT]
[AUTO PAIRING]
[INITIALIZE]
[INFORMATION]
.
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
" " appears in front of the current playback audio device.
• You can connect a maximum of two Bluetooth phones and one Bluetooth
audio device at a time.
1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
Changes the PIN code (up to 6 digits).
1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
[ON]: The unit is automatically reconnect when the last connected
Bluetooth device is within the connectable range. ; [OFF]: Cancels.
(For KD-X472BT)
[ON]: The unit is automatically paired with the supported Bluetooth
device (iPhone/iPod touch) when it is connected through USB input
terminal. Depending on the operating system of the connected device, this
function may not work. ; [OFF]: Cancels.
[YES]: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; [NO]: Cancels.
[MY BT NAME]: Displays the name of your receiver ("KD-X472BT"/
"KD-X272BT"). ;
[MY ADDRESS]: Shows address of this unit.
Default: [XX]