Advertisement
ETHERNET CONNECTION
There is a RJ-45 jack on the rear panel of this amplifier for the connection to Ethernet.
Please use a good quality Cat5e/5 cable, and follow the connecting diagram below.
1. Connect the LAN port on the rear panel of controller to the local Wi-Fi Router.
The Ethernet connection mainly for Wi-Fi control via APP or other control devices.
Note: When controlling via ETHERNET, please make sure the ETHERNET/RS232 switch is
set at ETHERNET position.
WI-FI CONNECTION
Because high stability and easy to setup, connecting to Ethernet via Cat5e/5 cable is
always recommended. In case wireless connection is needed to use for the installation,
please follow the below steps to setup the Wi-Fi connection:
1.Power on MAP-1200EW and make sure the amplifier is not out of Wi-Fi range of router.
2.Using PC, Smart phone or Tablet (PC is recommended), searching the Wi-Fi
connection and find out the Wi-Fi signal from this amplifier.
3.Connect to the Wi-Fi of this amplifier.
SSID: LINK Password: 12345678
4.Please visit http://192.168.16.254 configuration webpage,
Default name: admin Password: admin
5.Click "AP Client", then "Apply".
The router will restart.
Router
PC
OR
PC
15
Advertisement
